الموضوع: محطات المحولات
عرض مشاركة واحدة
  #7  
قديم 01-31-2012, 11:38 AM
الصورة الرمزية م / على مدكور
م / على مدكور م / على مدكور غير متواجد حالياً
عضو مميز
 
تاريخ التسجيل: Jan 2011
الدولة: مصر
المشاركات: 796
معدل تقييم المستوى: 14
م / على مدكور is on a distinguished road
افتراضي

What is power factor?...
Power factor is the ratio of true power or watts to apparent power or volt amps. They are identical **ly when current and voltage are in phase than the power factor is 1.0. The power in an ac circuit is very seldom equal to the direct product of the volts and amperes. In order to find the power of a single phase ac circuit the product of volts and amperes must be multiplied by the power factor. Ampmeters and voltmeters indicate the effective value of amps and volts. True power or watts can be measured with a wattmeter. If the true power is 1870 watts and the volt amp reading is 2200. Than the power factor is 0.85 or 85 percent. True power divided by apparent power. The power factor is expressed in decimal or percentage. Thus power factors of 0.8 are the same as 80 percent. Low power factor is usually associated with motors and transformers. An incandescent bulb would have a power factor of close to 1.0. A **e hp motor about 0.80. With low power factor loads, the current flowing through electrical system comp**ents is higher than necessary to do the required work. This results in excess heating, which can damage or shorten the life of equipment, A low power factor can also cause low-voltage c**diti**s, resulting in dimming of lights and sluggish motor operati**.
Low power factor is usually not that much of a problem in residential homes. It does however become a problem in industry where multiple large motors are used. Power Factor Correcti** Capacitors are normally used to try to correct this problem



رد مع اقتباس